Kurzweil Forte SE - The DSP Modulation (DSPMOD) Page

Program Edit Mode
The DSP Modulation (DSPMOD) Page
7-39
Each eld in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand elds—as noted
in Common DSP Control Parameters on page 7-33, any adjustments made to the function-
parameters on the DSPCTL page are reected in the corresponding function-parameters
on the DSPMOD page. e right-hand side of the DSPCTL page is the subpage of the
highlighted function-parameter—on the subpage are the ne adjust parameters and hard-
wired parameters. To access the parameters on the subpage, highlight the function-parameter
you wish to edit, and then press the > button to move the cursor into the subpage. e label
of a function-parameter depends on its corresponding function-block in the current layer’s
algorithm. e above DSPCTL page corresponds to the following algorithm:
The DSP Modulation (DSPMOD) Page
Before reading further, be sure to read Algorithm Basics on page 7-32 and Common DSP
Control Parameters on page 7-33.
Press the DSPMOD soft button to call up the DSP Modulation (DSPMOD) page, which is
displayed below:
Parameter Range of Values Default
Source 1 Control Source List Off
Depth (Depends on Function) 0
Source 2 Control Source List Off
Depth Control Control Source List Off
Minimum Depth (Depends on Function) 0
Maximum Depth (Depends on Function) 0