Kurzweil Forte SE - The OUTPUT Page

Program Edit Mode
The OUTPUT Page
7-40
Each eld in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand elds—as noted
in Common DSP Control Parameters, any adjustments made to the function-parameters on
the DSPMOD page are reected in the corresponding function-parameters on the DSPCTL
page. e right-hand side of the DSPCTL page is the subpage of the highlighted function-
parameter—on the subpage are the programmable parameters. To access the parameters on
the subpage, highlight the function-parameter you wish to edit, and then press the > button
to move the cursor into the subpage.
Each function-parameter’s subpage contains the programmable parameters of the highlighted
function-parameter. By assigning control sources to modulate a function-parameter, you
can enable real-time control of your program’s sound and behavior. You can assign Src1 to
any control source, and can specify its maximum value with the Depth parameter. Src2 is
dierent—you can assign it to any control source, but can also assign a control source to its
maximum value with the DptCtl parameter. You can then specify the range of Src2’s depth
with the MinDepth and MaxDepth parameters.
e label of a function-parameter depends on its corresponding function-block in the current
layer’s algorithm. e above DSPMOD page corresponds to the following algorithm:
The OUTPUT Page
Press the OUTPUT soft button to get to the OUTPUT page, where you set the layer’s pre-
and post-FX panning. ere are actually four dierent congurations of the OUTPUT page;
which one you see depends on whether the current layer uses a stereo keymap, and whether it
uses program FX or layer-specic eects (more on this in The Program FX (FX) Page on page
7-14 and The Layer FX (LYR_FX) Page on page 7-16).
Note: e Forte SE features an easy shortcut for quickly assigning any of the Forte SE’s
realtime controllers (sliders, wheels, buttons, etc). to a currently selected parameter (such
as the Src1 and Src2 parameters above). Simply hold the Enter button and move the
desired controller.