Program Edit Mode
The Parameters (PARAMS) Page
7-10
On the Parameters page, you can press the Edit button to see a Parameters Destination eld,
which shows the CC number that it sends to parameters on the VAST pages. A parameter’s
Destination is automatically set when the Parameter is created, and can not be changed.
Alternatively, if you have changed Control assignments on the Parameters page and are no
longer sure which VAST source assignment goes with which Parameter on the Parameters
page, you can quickly nd the associated parameter by selecting the VAST source eld
and pressing the Edit button. is will jump to selecting the associated parameter on the
Parameters Page.
The Parameters (PARAMS) Page
Press the PARAMS soft button to display the Parameters page.
Column Range Of Values
Parameter Program / Effect Chain dependent
Control Physical controller or MIDI CC
Value None, 0 to 127
e Parameters page shows a list of every parameter in the current program that has been
assigned to be controlled by one of the Forte SE’s physical controllers (or by an external
MIDI CC number). e Parameters page allows you to edit the name displayed for each
controller assignment, select a dierent controller assignment, and set an initial MIDI value
for each controller assignment. All VAST, KB3 and FX parameters that have been assigned
to a controller or MIDI CC number are shown. When controller or MIDI assignments
are made on other Program or FX Edit pages, or if an FX Chain is selected which contains
controller assignments, these parameters are automatically added to the Parameters page.
Parameter
e Parameter (left) column shows a list of every parameter in the current program that has
been assigned to be controlled by one of the Forte SE’s physical controllers (or by an external
MIDI CC number). Eect Chain parameters are named with prexes based on their eect
type, either “INS” for parameters from Insert eects, "LFX" for parameters from layer eects,
or “AUX1/AUX2” for parameters from Aux eects.
To Next Page
Loading...
