Kurzweil Forte SE - The Program FX (FX) Page

Program Edit Mode
The Parameters (PARAMS) Page
7-14
The Program FX (FX) Page
Press the FX soft button to call up the Program FX (FX) page. is is the page that you will
use to apply eects to a program, and to congure the routing of the various pre- and post-
FX audio signals. Eects chosen on this page aect every layer of the current program. e
section The Layer FX (LYR_FX) Page on page 7-16 contains information on using layer-
specic eects. e FX page looks like this:
Parameter Range of Values Default
Insert Chain List 0 None
Aux 1, Aux 2 Chain List 0 None
Output Main, Sec. Main
Auxiliary Send
Parameters
Aux Send (dB) off, -95 to 24 decibels 0
Aux Send (%) 0 to 100% 0
Aux Pre/Post Insert Post, Pre Post
Type dB, % dB
Aux Modulation Control Source List On
On the Forte SE, a program can have up to 11 insert eects and 2 aux eects using up to
32 DSP “units.” An insert is essentially just an eect that you apply to a program or layer,
while aux eects receive signal from all active programs’ aux sends. Note the 0/0 Units in the
middle of the top line of the page. is gure indicates how many of the total units are being
used by the highlighted insert; the left-hand number is the size of the insert, and the right-
hand number is the total number of units being used by the program.
If you exceed the maximum number of DSP units, the Forte SE will notify you that you have
done so, and no eects will be applied to the program.
Insert
e Insert eect is the eects chain that is applied to the main audio bus. When the Insert
eld is selected, you can press the Edit button to edit the current Chain. For details on Chain
editing see Chapter 8, e Eects Chain Editor.