Kurzweil Forte SE - BEND Page; CCTLS (Ccs;Continuous Controllers) Page

Multi Edit Mode
BEND Page
11-13
e values can be anywhere from 1 to 127. As with other parameters, zones can overlap or
be totally discrete, or be identical. Usually, LoVel will have a smaller value than HiVel, but as
with LoKey and HiKey, you may also create a gap in velocity response, by setting HiVel to a
lower value than LoVel.
BEND Page
Parameter Range Of Values Default Value
Bend Up ST Prog, 0 to 127 ST (semitones) 2 ST
Bend Down ST Prog, 0 to 127 ST (semitones) 2 ST
Bend Up cT 0 to 100 cents 2 ST
Bend Down cT 0 to 100 cents 2 ST
Bend Up / Down ST
Bend Up ST and Bend Down ST sends a bend range message to an internal program or
a MIDI device, telling it how to dene subsequent pitch bend messages. You can set this
parameter to any value between 0 semitones and 127 semitones, or to Prog, which uses the
Bend Range Up / Down of the currently selected Program for the Zone. e value can be
entered numerically, and entering -1 will select Prog. (value that the Program would use in
Program Mode).
Bend Up / Down CT
Bend Up CT and Bend Down CT lets you ne tune the value for Bend Up ST & Bend
Down ST (semitones). 100 cents equals one semitone, or one half step; you can set this
parameter anywhere between 0 and 100 cents.
CCTLS (CCs/Continuous Controllers) Page
Parameter Range Of Values Default Value
Controller See Continuous Controllers List -
Mode Off, MIDI CC -
Destination See Controller Destination List -
Scale -300% to +300% 100%
Add -128 to 127 0