Kurzweil Forte SE - Page 146

Program Edit Mode
The Utility Soft Buttons, HELP Soft Button and Favorites Buttons Functions
7-77
1 Block:
LPNOIZ
A noise generator combined with a low pass lter. Use the Noiz Frq parameter to control the
cut o frequency of the lter.
NOISE
A simple noise generator. Use the Noise parameter to control the noise initial amplitude.
SW + SHP (Sawtooth + Shaper)
is oscillator is capable of basic FM Synthesis. Its distinctive parameter is Pch Coar. is
oscillator must come after the sound source in an algorithm (either keymap or oscillator)
in order to hear the eect of Pch Coar, which can radically change whatever the oscillator
receives as an input. Works well placed after a Sine source.
SINE+ [Aliased (not recommended)]
Same as 2 block version, but without the Sine+Am parameter.
SAW+ [Aliased (not recommended)]
A saw oscillator that can add an input signal to its output.
NOISE+ [Aliased (not recommended)]
A noise oscillator that can add an input signal to its output.
2 Block:
SINE+
A sine oscillator that can add an input signal to its output. e Sin+ Pch and Sine+ Am
parameters aect the pitch and amplitude of the sine waveform without aecting the pitch of
the input source.
RES NOISE
A noise generator combined with a low pass lter with resonance control. Use the Noiz Frq
parameter to control the cut o frequency of the lter. Use the Noiz Q parameter to control
the amplitude of the resonance (a boost or cut at the cut o frequency). One technique for
use of this function is to set a high value for Noiz Q (so that you hear a the resonance create
a tone,) and then on the DSPCTL page set C4 as an initial frequency for Noiz Frq, and
set Keytrk to 100ct/key on the Noiz Frq sub page. Doing this causes the noise resonance
frequency to match the note of the key played.
SHAPED SAW
e Shaped Saw oscillator is a sawtooth oscillator with the ability to morph its output shape
between sawtooth and sine wave (without crossfading). is oscillator’s distinctive parameter
is Shape, which controls the morphing. With Shape set to 0, the oscillator produces a pure
sawtooth wave. With Shape set to 127, the oscillator produces a pure sine wave. Values in
between morph between the two wave shapes.