Kurzweil Forte SE - Page 236

Multi Edit Mode
SWITCH (Switches) Page
11-18
FORTE SE SWITCHES
Sw.Pedal1a Variation Button
Sw.Pedal1b ArpSwitch
Sw.Pedal2a Switches 1-9
Sw.Pedal2b Key 1-12
Mode
Switch Controllers have three modes: O, MIDI CC, or Chord.
With a value of O, the controller is disabled for this zone.
With a value of MIDI CC, the controller has the ability to transmit MIDI control messages.
Switch controls can also be set to Chord mode. In Chord mode, the switch can play a chord
containing up to 8 notes.
Velocity
e Velocity parameter only appears if the Mode is set to “Chord” and is for use with switch
controllers. Use the Velocity parameter to select a MIDI attack velocity (0-127) for the
note(s) designated in the Key1 to Key8 eld(s). Alternatively, set the Velocity eld to Auto
and the note’s velocity will be the velocity set by the KeyVel Multi Destination (see KeyVel
on page 11-21).
Key1.....Key8
e Key1, Key2, Key3, Key4, Key5, Key6, Key7, Key8 parameters are available when the
Mode is set to “Chord” . Use the Key(1 to 8) parameters to select the note to be played. e
note is displayed by MIDI note name.
To select a note, select the KeyNum eld with the navigation buttons, hold the Enter button
on the alphanumeric pad, then play the desired note on the keyboard. You can also change
the note in the eld by using the Alpha Wheel or Previous-/Next+ buttons.
Key
When the Switch parameter is set to a Key (Key1-Key12) and Mode is set to something
other than “O”, the Key parameter appears. Use the Key parameter to select which of the
Forte SE’s Keys you wish to use as a switch controller. With the Key parameter selected, you
can set a key by holding the Enter button and striking the desired key.