EasyManua.ls Logo

Kurzweil Forte SE - Page 278

Kurzweil Forte SE
374 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Global Mode
AUD-IN (Audio Input Page)
12-25
In Multi Mode, if a Multi is selected which has its Audio Input Mode set to “Use Global
Mode Eects”, any Mods assigned within the selected Audio Input Chain can be controlled
by controllers assigned in a Zone set to the same MIDI channel as the current Multis
AuxFXChan. See the MODs section below for more details.
MODs
Eect Chain Mods are modulation controls which can be assigned to the Forte SE’s physical
controllers. For example, an Eect Chain Mod assigned to a slider can be used to adjust the
dry/wet eect mix, or control other parameters like reverb or delay time.
e MODs eld lists the CC numbers associated with each Mod. When the “Control
parameter is set to “Current Channel Control”, Mods assigned within the selected Audio
Input Chain can be controlled by controllers sending the same CC numbers from the
currently selected Program or Multi.
e MODs eld displays any MIDI CC numbers which have been assigned to control FX
Chain Mods within the selected Audio Input Chain. To view which parameters these CC
numbers are assigned to, select the Chain eld and press the Edit button to enter the Chain
Editor, then go to the Chain Info page (see Ch. 8 The Effects Chain Editor for details).
Audio Input Mods in Program Mode
To control Audio Input Mods in Program Mode, rst make sure the Global “Control”
parameter is set to “Current Channel Control”. In Program Mode, the Forte SE’s physical
controllers send the MIDI CC numbers listed in the table below. If the selected Chain
contains Mods which use any of these MIDI CC numbers, eects parameters will be
controllable by using the physical controllers which have corresponding MIDI numbers.
Use the Chain editor if you wish to add Mods, remove Mods, or change their MIDI
assignments. Select the Chain eld and press the Edit button to enter the Chain Editor. See
The MOD Pages on page 8-2 for details on editing Chain Mods.
Forte SE Controller MIDI CCs
Mod Wheel (MIDI 1) Slider H (MIDI 27) Switch 3 (MIDI 82)
CC Pedal (MIDI 11) Slider I (MIDI 28) Switch 4 (MIDI 83)
Slider A (MIDI 12) Variation Switch (MIDI 29) Switch 5 (MIDI 85)
Slider B (MIDI 13) Sw. Pedal 1a (MIDI 64) Switch 6 (MIDI 86)
Slider C (MIDI 22) Sw. Pedal 1b (MIDI 66) Switch 7 (MIDI 87)
Slider D (MIDI 23) Sw. Pedal 2a (MIDI 66) Switch 8 (MIDI 89)
Slider E (MIDI 24) Sw. Pedal 2b (MIDI 67) Switch 9 (MIDI 90)
Slider F (MIDI 25) Switch 1 (MIDI 80)
Slider G (MIDI 26) Switch 2 (MIDI 81)

Table of Contents

Other manuals for Kurzweil Forte SE

Related product manuals