Kurzweil Forte SE - Page 297

Song Mode and the Song Editor
Song Mode: The METRONOME Page
13-13
CountOff
This parameter determines the number of measures the Forte SE will count o before recording.
With StartOnly selected, the Forte SE will only count o at the beginning of a sequence. With
Always selected, the Forte SE will count o from any point in a sequence.
Program
This parameter determines the program with which the metronome is played. If you wanted a
piano for a metronome, for instance, you could set Program to a piano program.
Channel
This parameter determines the MIDI channel to which the metronome program and events are
sent.
Strong Note
This parameter determines the MIDI number of the note played by the metronome for the
downbeats (the “1” of each measure).
Strong Vel
This parameter determines the velocity of the note played by the metronome for the downbeats
(the “1” of each measure).
Soft Note
This parameter determines the MIDI number of the note played by the metronome for all beats
other than the rst beat of each measure.
Soft Vel
This parameter determines the velocity of the note played by the metronome for all beats other
than the rst beat of each measure.
The Rec, Play, and Stop Soft Buttons
These soft buttons function as described in “The Rec, Play, and Stop Soft Buttons” on page 13-12.
The Done Soft Button
If no changes were made in the METRONOME page, pressing the Done soft button calls up the
MAIN page. If changes were made, pressing the Done soft button calls up the “Save Changes”
dialog.