Troubleshooting
Common Problems
15-2
e wall outlet, power strip, or
extension cord is defective or
damaged.
Use a dierent wall outlet, power strip, or
extension cord.
If there’s evidence of the unit receiving power, but operation is abnormal, check if one of the
following might be the issue:
e wall outlet voltage is below 90
volts due to overload.
Try a dierent outlet on a dierent circuit.
Powers up, Display is Blank
e Display is blank or dicult to
read.
Slowly turn the Display contrast knob
(located above the Alpha Wheel) to adjust the
Display.
Audio Problems
CAUTION: Do not trouble shoot audio problems using headphones.
Additionally, always be aware of the volume levels on the Forte SE and
on the connected audio system or mixer.
NOTE: When diagnosing audio problems, set the Forte SE to play its Demo Song rather
then intermittently pressing keys. is will prevent any unexpectedly loud volume changes.
If there is no sound from your Forte SE, check if one of the following might be the issue:
e volume slider is turned down. Slowly push the volume slider up.
e volume control on the audio
system or mixer is turned down.
Slowly turn the volume control up.
e signal source selection on the
audio system or mixer is incorrect.
Set the volume of the audio or mixer to the
lowest level, select the correct signal source,
and then slowly turn up the volume.
To Next Page
Loading...
