Program Mode
The Split and Layer Functions
6-12
Layer Function
When you create a Layer in Program Mode, you are also creating a Multi with two active
Zones, each using the same keyboard range. e Program you were using in Program Mode
is used as the Program for Zone 1. After this you can choose a Program that will be used for
Zone 2.
e default Program parameter for a Layer is 130 Adagio Strings, and the default keyboard
range is C1 - G9. Use the navigation buttons to access each of the Split/Layer parameters.
Other parameters that determine the behavior of the Multi are described below. Use the
navigation buttons to access each of the Split/Layer parameters.
Once you have saved your Layer as a Multi, you can continue to add Split or Layer Zones
to the Multi until you reach the maximum number of active Zones. See below for details on
saving.
Split/Layer parameters
Zn and Stat (Zone and Status)
Selecting Split or Layer makes Zone 2 active. You can continue to add Zones to the Multi
by activating additional Zones with the Stat parameter or the front panel Zone buttons. e
Forte SE will display a message if you have already reached the maximum number of active
Zones (see Chapter 10, for more information on Multis).
To Next Page
Loading...
