Kurzweil Forte SE - Page 95

Program Edit Mode
The LAYER Page
7-26
Parameter Range of Values Default
Bend Off, Key, All All
Trig Normal, Reversed, Pedal Down, Pedal Up Normal
Delay Control Control Source list Off
Minimum Delay 0 to 25 seconds 0
Maximum Delay 0 to 25 seconds 0
Layer Enable Control Source list On
Enable Sense
Enable Min
Enable Max
Normal, Reversed
± 127
± 127
Normal
64
127
Opaque Layer Off, On Off
Sustain Pedal Off, On, On2, On3 On
Sostenuto Pedal Off, On On
Freeze Pedal Off, On On
Ignore Release Off, On Off
Hold Through Attack Off, On Off
Hold Until Decay Off, On Off
Low Key (LoKey)
is sets the lowest active note for the current layer. is parameter’s value cannot be set
higher than the value for HiKey. e standard MIDI key range is C 1—G 9 (0-127). Middle
C is C 4.
High Key (HiKey)
Here you set the highest active note for the current layer. is parameter’s value cannot be set
lower than the value for LoKey.
Low Velocity (LoVel)
With this parameter you dene the lowest attack velocity at which the layer will be enabled
(generate a sound). e values for this parameter and the next are expressed in the standard
musical dynamics markings, similar to the values available for the velocity maps. Attack
velocities that are below this threshold will not trigger notes. If you set this parameter’s value
higher than the HiVel value, the layer will not play at all.
High Velocity (HiVel)
Similarly, this will set the highest attack velocity at which the layer will be enabled. Attack
velocities above this threshold will not trigger notes in this layer.