Kurzweil Forte SE - Page 98

Program Edit Mode
The LAYER Page
7-29
Using this parameter in conjunction with the Enable parameter, you can easily create
velocity-switching for as many layers as you have in your program. is is useful for drum
programs, since you can dene a dierent velocity-trigger level for each of the 32 layers
available in drum programs.
First, set the Enable parameter for the Layer 1 to a value of GAttVel (global attack velocity).
is causes the layer to play based on the attack velocity of your keystrokes. en set the
Enable Sense (S) parameter to a value of Norm, and adjust its minimum and maximum
values (the two numerals to the right of Norm) to a narrow range. Don’t use negative values,
since they don’t apply when you’re using GAttVel as the layer enabler.
Repeat this for each layer in the program. Bear in mind that if you want to set up 32
dierent velocity levels for a program, with equal intervals between each layer, then you have
a range of 4 for each level (Layer 1 is 0–3, Layer 2 is 4–7, and so on).
Opaque
An opaque layer blocks all higher-numbered layers in its range, allowing only the opaque
layer to play. is is an easy way to change a small range of notes in a program, leaving the
original sound playing above and below the new sound.
Start with a one-layer program, and create a new layer (Layer 2) with the NewLyr soft
button. On the KEYMAP page for Layer 2, select the keymap you want to use, then on the
LAYER page, set Layer 2’s range (say, C 3 to D 3), and set its Opaque parameter to On.
en go to Layer1, and duplicate it (with the DupLyr soft button); the duplicate layer
becomes Layer3. You now have a three-layer program. Delete Layer 1 (the original layer);
Layer 2 (the new layer you created) becomes Layer 1, and Layer3 becomes Layer2. Now
Layer2 blocks out Layer3 (the duplicate of the original layer) at the notes C3–D3.
Sustain Pedal (SusPdl)
When this parameter is on, the layer will respond to all sustain messages (Controller
destination 64, Sustain). When o, the current layer will ignore sustain messages. On2
means that the sustain pedal will not catch the release of a note that is still sounding when
the sustain message is received; this can be very useful in a program that uses amplitude
envelopes with a long release time.
On3 enables the use of half damper pedal techniques when using a compatible continuous
switch pedal (such as the Korg DS-1H). On3 emulates the behavior of an acoustic piano’s
sustain pedal by increasing the release portion of the current layer’s amplitude envelope as the
pedal is pressed down, before becoming fully sustained. is allows you to use a sustain pedal
to control note release length and sustain.