Kurzweil K2000 - MUSICIANS GUIDE - Page 115

MIDI Mode
The Channels Page
10-9
MIDIMode:CHANNELS||||||||||<>Channel:1||
Enable||:On|||||||||||||||||||||||||||||
Program|:1|Grand|Piano|||||||PrgLock:Off
Pan|||||:64||||||||||||||||||PanLock:Off
Volume||:127|||||||||||||||||VolLock:Off
OutPair|:Prog|||||||||||||||||||||||||||
OutGain|:Prog|||||||||||||||||||||||||||
XMIT|||RECV|||CHANLS|PrgChg|RsetCh|Panic
PARAMETER RANGE OF VALUES DEFAULT
ENABLE Off, On On
PROGRAM Program list Program ID 1
PAN 0 to 127 64 (centered)
VOLUME 0 to 127 127 (maximum)
OUTPUT PAIR Prog, A (FX), B (DRY), C(DRY), D(DRY) Prog
OUTPUT GAIN Prog, –12 to 30 dB in 6 dB increments Prog
PROGRAM LOCK Off, On Off
PAN LOCK Off, On Off
VOLUME LOCK Off, On Off
Enable
Use this parameter to turn the currently selected channel on or off. When on, the channel will
receive MIDI information, and the settings of the parameters on the MIDI CHANLS page will
be in effect. When off, the channel will ignore all MIDI information.
Program
Use this parameter to assign a program to the currently selected channel. The channel will still
respond to program change commands received via MIDI, unless the PrgLock parameter
(described below) is set to On.
Pan
This will offset the pan position of the current program as set on the OUTPUT page in the
Program Editor. A value of 0 is maximum offset to the left, 64 is no offset, and 127 is maximum
offset to the right. Changing the value of this parameter is like inserting a MIDI pan message.
MIDI Pan (MIDI 10) messages will change the value of this parameter, unless the PanLock
Parameter (described below) is set to On.
Volume
This sets the volume for any program assigned to the currently selected channel. A value of 0 is
silence, and a value of 127 is full volume. The value of this parameter will change in response to
MIDI Volume (MIDI 07) messages, unless the VolLock parameter (described below) is set to On.
Output Pair (OutPair)
This parameter sets the audio output group for the program assigned to the currently selected
channel. The default value of Prog means that the output group is determined by the programÕs
value for the Pair parameter on the OUTPUT page in the Program Editor. In this case, the
channelÕs output group will change depending on the program assigned to it, with the output
group being routed on a per layer basis within the program. Values of A B, C, or D Þx the
output group regardless of the program thatÕs assigned to the channel.