Song Mode
Edit Song: EVENT Page
12-28
ARRANG enters the EditSong : ARRANG page, gaining access to a group of arrangement
speciÞc parameters.
Edit Song: EVENT Page
Every type of recorded MIDI event is visible from this page. You can view and change these
events if necessary.
To scroll through the events, make sure the Þrst column bar and beat is highlighted. Use the
wheel, the up and down cursor buttons, or the + and - buttons. As you scroll through the
events, each event is executed by the sequencer. In the case of note events, you will hear the
note played, although the duration will be short. If you have scrolled through a Sustain
(controller 64) message with an On value then you will hear the note sustain as if the sustain
pedal was depressed. The note will continue to sustain until you scroll through a Sustain
message with a value of Off.
You can also jump directly to a speciÞc bar and beat by typing the bar number and beat
number, then pressing ENTER. Keep in mind if you have controller or program data previous
to the point that you jump to, those events may not have been executed and you may hear
unexpected results. For instance, if you have program changes at bar 1 and bar 8, then if you
jump from bar 1 to bar 9 any notes you scroll through will be played with the program change
from bar 1.
The channel of the selected Event is displayed on the top line of the page. When all of the
Tracks are being viewed in the Event List, the Track of the selected Event is displayed along
with its channel. Use the CHAN/BANK buttons to select an active track to view and edit the
MIDI events recorded on it. You can view the data on all tracks by pressing both CHAN/BANK
buttons at the same time. As you scroll through each Event, the track, in addition to the
channel, for the selected Event will also be displayed.
Location
The Þrst column represents the Bar and Beat Locations of the different events in a Song. Scroll
through the events on the selected track(s) with the Alpha Wheel or enter in a speciÞc Bar and
Beat on the numeric keypad to jump to events occurring on that Beat. A quick way to jump to
the End point in a track is to press 9999 and then Enter on the numeric keypad.
Bar, Beat, and Tick
Bar, Beat, and Tick are editable parameters for each Event. They determine when an Event
happens relative to the other Events within the Song. To enter values with the numeric keypad,
Þrst position the cursor in this column and then simply enter up to three digits if you only want
EditSong:EVENT||(Ch|1)|||||||<>Track:1||
|||1:1||||1:1.000|CTRL|BANK|||0|||||||||
Location
|||1:1||||1:1.000|PCHG|||64|||||||||||||
|||1:1||||1:1.000|CTRL|VOL||127|||||||||
|||1:1||||1:1.000|CTRL|PAN|||64|||||||||
|||1:1||||1:1.000|C|3||v|98|^|93|||0.356
|||2:1||||2:1.000|END|||||||||||||||||||
|Cut||||Copy||Paste|||View||AllOn||Done|
Bar:Beat:Tick Event Type and Value
To Next Page
Loading...