Kurzweil K2000 - MUSICIANS GUIDE - Soft Buttons on the Edit Song: EVENT Page

Song Mode
Edit Song: EVENT Page
12-29
to adjust the Tick value, four or Þve digits in order to change the location to a new Beat and Tick
within the current Bar, or enter in the complete Bar, Beat, and Tick value to relocate the event to
another Bar. No punctuation is necessary when entering any of these values.
Event Type and Value
The Event Type Þeld displays the MIDI event type at each Event List location in the Song. With
the exception of a Note event, which is displayed as the actual note name (e.g., C#4), an event
type cannot be changed to another event type. You can also change controller numbers and
values on the EVENT page.
The PCHG, BEND, MPRS, SYSX, TMPO, and END events will show their values in the display
Þeld directly to the right of the Event Type Þeld. All of their values can be edited. Here are the
ranges of values for each event type:
Program Change (PCHG) 0 - 127
Pitch Bend (BEND) (-8192) - 8191
Mono Pressure (MPRS) 0 - 127
System Exclusive (SYSX) The message in hexadecimal form
Tempo (TMPO) 1.00 - 255.00 bpm
End Point (END) Any Bar : Beat : Tick setting
Note events have four editable values: Note Number, Attack Velocity (indicated by a "v"),
Release Velocity (indicated by a "^"), and Note Duration.
Note Number C-1 Ð G9
Attack Velocity v1 - v127
Release Velocity ^1 - ^127
Note Duration Beats : Ticks
Controller events have two editable values: Controller Type and Controller Value. DeÞned
controllers are referred to by their names.
Controller Type 0 - 127
Controller Value 0 - 127
Soft Buttons on the Edit Song: EVENT Page
Cut removes the currently selected event from the Event List and temporarily stores it in a
memory buffer so that you can immediately Paste it into a new location.
Copy makes a duplicate of the currently selected event and temporarily stores it in a memory
buffer so that you can immediately Paste it into a new location.
Paste inserts the most recent cut or copied event into the Event List at the currently selected Bar
: Beat : Tick location. The pasted event will share the same location with the event that already
existed at that location in the Event List, but it will appear before the pre-existing event.
View brings you to the EVENT : View page where you can set the view Þlter parameters for the
Event List.