Disk Mode
The Multiple Object Selector Page
13-32
The Multiple Object Selector Page
The Multiple Object Selector is used for making multiple selections of objects from an object
list according to combinations of selection modes such as object type, object ID, and
dependencies. This page is available for use in the Load Object dialog, the Save Object dialog,
and all of the object utilities that are described in the Master mode chapter (Move, Copy, Name,
Delete, and Dump Objects.)
The Multiple Object Selector page is entered by pressing the Multi soft button when in the
dialog pages for the above functions. This page contains parameters to deÞne a group of
objects cross-referenced by object type and object ID. Objects can be grouped according to the
dependencies of one or more objects, for all of the object functions except Load Object. (As
described previously, the Load Object function can not determine exact object dependency
relationships until the objects are actually being loaded into the K2vx. The other object
functions operate on lists of the objects currently stored in the K2vx's RAM, and because of this,
dependent relationships are available to be used as selection criteria.)
This is what is displayed by the K2vx when the Multi button is Þrst pressed:
Multiple|Object|Selector||||||||||||||||
Select|:Type/Range||||||||||||||||||||||
Type|||:Sample||||||||||||||||||||||||||
Bank|||:200's|||||||||||||||||||||||||||
StartId:|200|||||EndId:|299|||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|All||||Type||Toggle|Clear|||Set||Cancel
This is the screen from which you can specify a range of object ID numbers cross-referenced
with object type. If you increment the Select parameter to the Dependents setting, you will see
the following additional parameter layout (not available for Load Object). This is used for
selecting dependent objects of either the object currently scrolled to (from the object list that
you were just viewing before pressing Multi) or dependent objects of the selected objects
(indicated with an asterisk in the object list):
Multiple|Object|Selector||||||||||||||||
Select|:Dependents||||||||||||||||||||||
Of|||||:Current|Item||||||||||||||||||||
Specify:All|||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Current|=|Program|205|Viola|Section|||||
||||||||||||||||||||||||||||||||||||||||
|All||||Type||Toggle|Clear|||Set||Cancel
The "Current =" parameter is for information only and represents the currently highlighted
item in the object list that you are working with.
Two other selection modes do not have any additional parameter associated with them. These
are Everything and Search String .
To Next Page
Loading...