Disk Mode
Macros
13-54
Press OK to enable the insert point. Press Cancel to disable the insert point.
The display will return to the "Load this Þle as:" dialog. If a Macro insert point has been set, an
indicator will appear at the top left of the screen:
(Macro|insert)||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||Load|this|file|as:200...299|||||||||||
||||||||||||||||||||300...399|||||||||||
||||||||||||||||||||400...499*||||||||||
||||||||||||||||||||500...599*||||||||||
Insert|||||||||||||||Macro|||OK|||Cancel
The insert point can be disabled before loading, by pressing Insert again and pressing Cancel
from within the "Set Macro Insert Point" dialog. The "(Macro insert)" indicator will disappear.
Similarly, the insert point can be changed before loading by pressing Insert again (the screen
will highlight the current insert point,) scrolling to a different insert point, and pressing OK.
Saving and Loading a Macro Table in a .KRZ file
Macro Table objects can be explicitly saved or loaded (without being "executed") using Save
Individual Object and Load Individual Object. If for some reason you wanted to save a Macro
Table that was being worked on "in-progress", and then be able to load it back in later on to be
worked on some more, you would use this method. The Macro Table can be selected for saving
and loading just like any other object. When you load in a Macro Table using Load Individual
Object, it will overwrite any Macro Table already in memory. Once it is loaded in, you may
have to go to the Macro page and enable Macro Record mode to continue to record further load
operations into the Macro.
The "Save Everything" feature of the Save dialog will not include the Macro Table. This is done
to prevent inadvertent distribution of what would most likely be a meaningless Macro Table to
other users.
Aborting a Macro Load
There is a way to abort the process of loading a Macro Þle. Aborting can only be done "in
between" Þles that are being loaded, and not during the load of any one Þle (short of powering
off or soft-resetting the machine with [simultaneously pressing [+/- 0 CLR]...but this is not
recommended!).
Aborting a Macro load is done by pressing and holding down either of the Plus (+) or the
Minus (-) buttons that are located just below the Alpha wheel. This should be done at least one-
half second before you anticipate the current Þle to Þnish loading, or else the K2vx will not
sense that you wish to abort the load.
You will see the following question after the current Þle being loaded is completed:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Abort|the|macro?||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||Yes||||No||
To Next Page
Loading...
Need help?
General
