Program Mode and the Program Editor
The Program Editor—Pages
6-17
Fine Hz
This measures pitch adjustment by the relative frequency (in Hertz) of each note. This is useful
for controlling the beat frequency between layers in a multi-layered program. Using this
parameter to detune chorusing layers will keep the beat frequency constant across much of the
keyboard. Although the ratio of frequencies between each layer remains constant, the detuning
will increase at lower pitches, and can become extreme. The K2vx automatically limits the
amount of detuning when it becomes extreme, so youÕll notice the beat frequencies moving out
of sync when you play low pitches.
F1–F3 Pages
These pages are reached by pressing the F1, F2, and F3 soft buttons, respectively. They contain
the parameters governing the three variable DSP functions in each algorithm. The pages vary
depending on the DSP functions selected for the three middle DSP control inputs, represented
by the downward-pointing arrows on the ALG page. See the Reference Guide for a complete list
of the algorithms and their available DSP functions.
The F4 AMP Page
Press the F4 AMP soft button to call up this page, which features Þve of the six common DSP
control parameters, in this case controlling the Þnal amplitude of the current layer before it
reaches the audio outputs. ThereÕs also a parameter that enables you to pad (attenuate) the
current layerÕs signal before its Þnal ampliÞcation.
EditProg:F4|AMP(FINAL|AMP)|<>Layer:1/1||
Adjust:6dB||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0dB||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.00dB/key||DptCtl:MWheel|||||||
VelTrk:20dB|||||||||MinDpt:0dB||||||||||
Pad|||:0dB||||||||||MaxDpt:0dB||||||||||
<more||F1|||||F2|||||F3|||||F4|AMP|more>
PARAMETER RANGE OF VALUES DEFAULT
ADJUST –96 to 48 dB 6
KEY TRACKING ± 2 dB 0
VELOCITY TRACKING ± 96 dB 20
PAD 0, 6, 12, 18 dB 0
SOURCE 1 Control Source list OFF
DEPTH ± 96 dB 0
SOURCE 2 Control Source list OFF
DEPTH CONTROL Control Source list MWheel
MINIMUM DEPTH ± 96 dB 0
MAXIMUM DEPTH ± 96 dB 0
Adjust
Adjust the overall amplitude (gain) of the currently selected layer. In multi-layer programs, this
parameter adjusts the amplitude of the layers relative to each other. This is the Þnal output
control for the layer (Post-amp pad). Be careful not to set this too high! If one of your layers is
too loud, itÕs generally better to cut its level than to boost the others. This will keep distortion to
a minimum.
To Next Page
Loading...
Need help?
General
