Programming Examples
Example 2
19-5
Edit|Prog:F2|RES(4P|LOPASS)|>Layer:1/1||
Adjust:|0.0dB||||||Src1||:Data||||||||||
|||||||||||||||||||Depth|:30.0dB||||||||
|||||||||||||||||||Src2||:OFF|||||||||||
KeyTrk:0.00dB/key||DptCtl:MWheel||||||||
VelTrk:0.00dB||||||MinDpt:0.00dB||||||||
|||||||||||||||||||MaxDpt:0.00dB||||||||
<more||F1|FRQ|F2|RES|F3|SEP|F4|AMP|more>
Next press either of the <more> soft buttons until you see the ENV2 soft button. Press it to
select the ENV2 page. Here youÕll program Envelope 2 to control the ÞlterÕs cutoff frequency.
The Att1 time parameter will already be selected; set its value to 0.50 seconds. Press the right
cursor button once to select the Att2 time parameter and set its value to 1.06 seconds. Cursor
down once to select the Att2 level parameter and set its value to -1%. Cursor right once, then up
once, selecting the Att3 time parameter. Set its value to 3.52 seconds. The ENV2 page should
look like the diagram below. Play around with the sound a bit. Hold a few notes through the
full length of ENV2; the sound will continue to change for several seconds. Work your
controllerÕs Mod Wheel and data slider through several different positions to get an idea of the
range of variation you can add by using the two control sources in tandem.
EditProg:ENV2|||||||[1/1]||<>Layer:1/1||
Att1:Att2:Att3:Dec1:Rel1:Rel2:Rel3:Loop:
0.50|1.06|3.52|0s|||0s|||0s|||0s|||Off||
100%|-1%||100%|0%|||0%|||0%|||0%|||Inf||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
<more||AMPENV|ENV2|||ENV3|||ENVCTL|more>
To Next Page
Loading...