System Exclusive Protocol
K2vx System Exclusive Implementation
30-8
The next four commands allow you to read the screen display, both text and graphics layers.
ALLTEXT = 15h
Érequests all text in the K2vxÕs display.
PARAMVALUE = 16h
Érequests the current parameter value.
PARAMNAME = 17h
Érequests the current parameter name.
GETGRAPHICS = 18h
Érequests the current graphics layer.
SCREENREPLY = 19h
This is the reply to ALLTEXT, PARAMVAL, PARAMNAME, GETGRAPHICS, or
SCREENREPLY.
The reply to ALLTEXT will be 320 bytes of ASCII text (the display has 8 rows of 40 characters
each). If you receive less than that, then the screen was in the middle of redrawing and you
should request the display again.
The reply to PARAMVALUE will be a variable length ASCII text string. Some values (like
keymaps, programs, samples, etc.) include their ID number in the text string (e.g., "983 OB
Wave 1"). Some messages are also padded with extra spaces.
The reply to PARAMNAME will be a variable length ASCII text string. In cases where there is
no parameter name (like on the program page) there will just be the single 00 null terminator.
The reply to GETGRAPHICS will be 2560 bytes of information. The 6 least signiÞcant bits of
each byte indicate whether a pixel is on or off. If pixels are on over characters, the text becomes
inverted. Characters on the K2vx display are a monospaced font with a height of 8 pixels and a
width of 6 pixels.
To Next Page
Loading...