KW Aufzugstechnik GmbH OPERATING MANUAL DAVID-613
DAVID-D613-V125-E 13.04.2021 Page - 74 -
PARAMETER: A2.2 TYPE OF CONTROLLER
With this parameter you can specify the following basic types of controls:
- One Button Exclusive
- One Buttoon Deadmean
- Preselection Controlling
- Two Button Collection
- One Button Up and Down Collection
- One Button Down Collection
- One Button No Collection
- Attendard Controlling
- Send-Controlling
- Taxi Controlls
PARAMETER: A2.3 GROUP
In this parameter, you can activate the group-drive. Please look at the points A2.4 and A2.5.
PARAMETER: A2.4 NO. OF LIFTS
In this parameter, you can put in the numbers of the lifts in the group. The maximum number is 8.
PARAMETER: A2.5 GROUP NO.
Each lift in the group has ist own number. You can give the lift a number between 1 and 8.
A3- Shaft
PARAMETER: A3.1 NO. OF FLOORS
In this parameter, you can put in the value, how many floors the elevator has. The maximum is eight
floors.
PARAMETER : A3.2 MAIN FLOOR
In this parameter, you can put in the value, of the main floor.
PARAMETER : A3.2 MAIN FLOOR-2
In this parameter, you can put in the value, of the main floor.
PARAMETER: A3.3 LOWEST FLOOR
If you have a group with a different number of floors, you must put in the number of the floor, which is
the lowest floor of the elevator.
PARAMETER: A3.4 DOOR SIDES
In this parameter, you can put in the value, how many door sides the elevator has. The maximum is
three door sides.
PARAMER: A3.5 SHAFT-COPY
In this parameter, you have to choose the type of shaft-copies:
- Standart-Copy
- Relativ-Copy
- Absolut-Copy
- Motor-Copy
- Minimum-Copy
- R&S-Copy
PARAMETER: A3.6 NOMINAL SPEED
In this parameter, you can put in the value of the nominal speed of the elevator in m/s.
To Next Page
Loading...