KW Aufzugstechnik GmbH OPERATING MANUAL DAVID-613
DAVID-D613-V125-E 13.04.2021 Page - 86 -
During the setting separately comes the car, with assigns which the landing priority button. The car
comes immediately. Car calls are deleted. Both external flash in the case of the time window call input.
With the mode of operation collective is needed only a landing priority button for 2 group of elevators.
With the first manipulation the next car comes. With a second manipulation the second cab comes.
With separately soft a certain elevator comes, the car and landing controller stay. This function used
at unequal groups, the cab drive in all floors.
In the case of separately emptying a certain elevator comes, but the lift goes out of the external control
and the car calls is processed. The input of new car calls is not possible, until the floor is reached the
landing priority. This function is used in order to introduce a hindrance drive without reducing the traffic
capacity of the group drastically.
Parameter: Priority Car Call – Target Floor (Floor xx)
If the setting has been selected and a corresponding long button press is exerted on a landing call, an
outside priority call is made. The prerequisite is that the setting "Collective" has been selected in pa-
rameter B24 Forced repetition and that the EA6 / 7 target repetition is assigned on the ER2014.
The elevator moves as quickly as possible to the pick-up floor from where it was called, without open-
ing the door and, if necessary reversing the direction of travel. Car calls are blocked on the pick-up
floor. A further journey is only possible by activating the transponder / key switch function (input func-
tion E998).
Only then does the journey take place in the target level. The elevator waits there with the door
opened until a car call is placed. After processing the car call, the elevator system goes back to nor-
mal operation.
Parameter: Forced overtaking – 5-second outgoing call (handicaped ride)
If the setting has been selected and a corresponding long press on an outside call is made,
an external priority call will be made. The prerequisite is that the setting "Single" has been
selected in parameter B24 Forced recovery.
In the parameter, the elevator system can be selected, which serves the outside priority call.
A shaft bus can serve up to 2 elevator systems. Therefore, it can be decided by the settings
A1 or A2 which elevator operates the priority outside call.
Disadvantage: Since the priority call is triggered by an outside call button, it can possibly
happen that a second elevator enters this level.
Parameters: Dangerous goods transport via key switch in the outer panel
The transport of dangerous goods can be activated in this parameter. There are 3 variants
available (see following page). The setting is made by selecting the setting (ON-1 or ON-2)
and activating the corresponding input and output functions.
To Next Page
Loading...