2M4/2M5/2M6/2M7-1
1-5-31
5. Remove main motor connector from the
Relay PWB.
Figure 1-5-48
6. Detach the connector from the paper
feed solenoid and unhook the harness
from the guide.
7. Detach the connector from the duplex
solenoid and unhook the harness from
the guide (25/26 ppm model only).
8. Detach the spring (25/26 ppm model
only).
Figure 1-5-49
Connector
Main motor
Relay PWB
Connector
(Duplex solenoid)
(25/26 ppm model only)
Spring
(25/26 ppm model only)
Connector
(Paper feed solenoid)
To Next Page
Loading...
