Kyocera KM-2560

2H0/2HZ-1
2-4-5
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Main charg-
ing/drum
section
Drum unit Replace 300K Replace. (Check and replace
when user call occurs.)
P.1-5-35
Main charger unit Clean User call Clean with a wet cloth and then a
dry cloth.
P.1-5-37
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Fuser
section
Fuser unit Replace 300K Replace. (Check and replace
when user call occurs.)
P.1-5-41
Heat roller Check or
replace
User call Replace when problem occurs. P.1-5-49
Press roller Check or
replace
User call Replace when problem occurs. P.1-5-45
Heat roller separation
claw
Check, clean
or replace
User call Check and clean with alcohol.
Replace if claw is deformed.
P.1-5-44
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Eject section Eject roller Check or
clean
User call Check and clean with alcohol.
Switchback roller Check or
clean
User call Check and clean with alcohol.
Eject pulley Check or
clean
User call Check and clean with alcohol.
Feed pulley Check or
clean
User call Check and clean with alcohol.
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Duplex
section
Upper duplex feed roller Clean 300K Clean with alcohol. (Check and
clean with alcohol when user call
occurs.)
Lower duplex feed roller Clean 300K Clean with alcohol. (Check and
clean with alcohol when user call
occurs.)
Duplex feed pulley Clean 300K Clean with alcohol. (Check and
clean with alcohol when user call
occurs.)