3-58
Maintenance > Parts Replacement
7
Replace the label (squared in red) that comes with the new
decurler unit according to the region of use, if necessary.
8
Attach the new unit in the reverse step of removing the decurl
unit.
9
[Home] key > [...] > [Professional Settings] > [U251 Clear
Maintenance Counter].
10
Select [05 Decurl] > [Start] key.
The counter for replaced part is cleared.
Check the status after replacement
Make a test print and check that there are no paper jams, double feed or no feed. If there is any problem, try again from
step 1.
If the problem is not resolved, contact your service representative.
To Next Page
Loading...
