5-2
Appendix > List of Professional Settings
List of Professional Settings
No. Item Description
000 Output Maintenance Report Print maintenance reports and status pages.
023 Reset Settings The adjustment setting value is restored to the factory default.
034 Adjust Paper Timing Data Adjust the tip edge timing and center line of paper.
059 Set Fan Mode Adjust the air flow of the drying conveyance fan motor according
to the paper type.
208 Set Deck Paper Size Configure the paper size to be loaded in cassettes 3 and 4.
246 Adjust Finisher Adjust various setting values when using a 4,000-sheet finisher,
Inverter and Decurler Unit, and 5,000-sheet stacker.
251 Clear Maintenance Counter Clear the counter value after replacing parts when the print image
reached 600,000.
327 Set Cassette Heater Control Switch the control mode of optional cassette heater integrated in
the machine.
407 Adj. Write Timing(Reverse) Adjust the writing timing of the back surface image drawing
position at duplex copying.
460 Adjust Conveying Sensor Adjust the double feed sensor threshold of the machine's
conveying sensor.
468 Color Regist Adj. Data Adjust the print head position of each color or the color drift.
700 Head Information Displays the print head temperature.
730 Set Head Cleaning Configure the purge strength and execution interval of head
cleaning.
731 Set Decurler Adjust the fan control of the decurl unit for the machine and the
Inverter Decurler Unit (DE-9100).
733 Set Warm Up Mode Configure the print head protection or the heater operation
control of the Inverter and Decurler Unit (DE-9100), during warm-
up operation.
734 Set Paper Discharge Mode Set whether to enable the discharge mode or print the wasted
paper.
735 Set Ink Temperature Control Adjust the printable ink temperature at Print Priority setting.
736 Set Waste Paper Specify the timing of ink discharge.
744 Set Head Cleaning Perform a stronger level of head cleaning than the settings in the
system menu to eliminate print head failure.
750 Set Head Coefficient Fine-tune the image density by adjusting the print head drive
voltage.
754 Adjust Discharge Width Adjust the width alignment cursor position to the paper width.
755 Adjust Conveying CIS Perform CIS position correction (center and side).
760 Set Color Bleeding Adjust the gap between colors when blur or void occurs in the
color boundaries.
917 Read/Write Backup Data Back up (export) the user Paper Catalog configured in the
machine and import it for use in another machine.
To Next Page
Loading...
