4-59
Troubleshooting > Troubleshooting When Discharging Paper
Remedy 4: Adding a correction value to support thick paper
1
[Home] key > [...] > [Professional Settings] > [246 Adjust
Finisher] > [01 Finisher] > [18 Punch(T) Resist]
2
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows.
3
Press the [Start] key > [Stop] key.
The staple position is misaligned
Remedy 1: Adjusting the position of the staples evenly from the center
1
[Home] key > [...] > [Professional Settings] > [246 Adjust
Finisher] > [01 Finisher] > [08 Staple HP]
2
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows.
If the staple position is shifted to the front side of the machine (Sample 1), increase the set
value.
If the staple position is shifted to the rear side of the machine (Sample 2), lower the set value.
Item Range Default Amount of change
18 Punch(T) Resist -20 to 20 0 0.15 mm
Cause Corrective Actions
Reference
Page
The center position of the
staples is misaligned.
Remedy 1: Adjust the position of the
staples evenly from the center.
page 4-59
The position of the front/back
staple is different from the
specified amount.
Remedy 2: Adjust the position of the front
or back staple.
page 4-60
Item Range Default Amount of change
08 Staple HP -30 to 30 0 0.19 mm
To Next Page
Loading...
