4-58
Troubleshooting > Troubleshooting When Discharging Paper
Remedy 2: Adjusting the stop timing of the position to open the punch hole
1
[Home] key > [...] > [Professional Settings] > [246 Adjust
Finisher] > [01 Finisher] > [02 Punch Feed]
2
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows.
If the position of the punched hole is shorter than the specified value, increase the set value.
If the position of the punched hole is longer than the specified value, lower the set value.
3
Press the [Start] key > [Stop] key.
Remedy 3: Adjust the positions of the punched holes evenly from the center
1
[Home] key > [...] > [Professional Settings] > [246 Adjust
Finisher] > [01 Finisher] > [03 Punch Width]
2
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows.
If the position of the punched hole is shorter than the specified value, increase the set value.
If the position of the punched hole is longer than the specified value, lower the set value.
3
Press the [Start] key > [Stop] key.
Item Range Default Amount of change
02 Punch Feed -10 to 10 0 0.30 mm
Item Range Default Amount of change
03 Punch Width -4 to 4 0 0.52 mm
Preset value A
9.75 mm (metric model)
0.25 inch (6.25 mm) (inch model)
Sample 1
Sample 2
Center line
To Next Page
Loading...
