4-24
Troubleshooting > Troubleshooting When Printing Image
6 Select an item.
Select [01 Main Scan] or [02 Sub Scan].
7 Change the value using the [+], [-] keys or the numeric keypad.
Select the values (0-9, A-I) read from the chart, enter the appropriate value.
8 Press the [Start] key > [Stop] key.
The entered value is reflected.
9 In case that no improvement is observed, then go to next step.
2
Paper load check
Loading Paper (Chapter 7) in Operation Guide
In case that no improvement is observed, then go to next step.
3
Clean the feed roller or retard roller
Slip with dirty roller.
1 Check dirt on the rollers and clean up dirty parts.
Parts Cleaning
(page 3-2)
2 In case that no improvement is observed, contact our service representative.
Front/Back position shift
1
Check paper
"Troubleshooting When Printing Image" > "Front/Back position shift" (Chapter 19) in
Operation Guide
In case that no improvement is observed, then go to next step.
2
Paper load check
Loading Paper (Chapter 7) in Operation Guide
In case that no improvement is observed, then go to next step.
3
Check the print zoom.
1 If you are using Fiery Controller, adjust the print zoom of the second side (back side) in
increments of 0.1%.
Printing System 50 user guides
You can download the user guide from the URL below.
https://services.efi.com/support/vfigs/3784295173/default.aspx
To Next Page
Loading...
