3-30
Maintenance > Replacement of Consumables
12
Rotate waste ink tank nozzle release lever [A] in the direction
of the arrow.
13
Close Front Cover 3.
Check the status after replacement
Make sure that no message is displayed on the control panel. If a message prompting for replacement or a message
indicating that the waste ink tank has not been installed is displayed, start from step 1 again.
If the problem is not resolved, contact your service representative.
Replacement of Cleaning Liquid Tank
When the head cleaning liquid is exhausted, the following message is displayed. Replace the head cleaning liquid tank
promptly.
"Head Cleaning Fluid is empty"
1
Open Front Cover 3 [A].
Before replacing the cleaning liquid tank, wear rubber gloves (powder free) to prevent liquid adhesion, and
spread a vinyl sheet to prevent head cleaning liquid from spilling on the floor.
To Next Page
Loading...
