4-64
Troubleshooting > Troubleshooting When Discharging Paper
3
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows. For example, in the case of single-sided printing on
the front side, there is a tendency to lower curl, so select [Air Ass On(DC)].
Increasing the value of [Air Ast On(TC)] resolves the non-feed to the stacker, but makes it
difficult to align the edges of the output paper. On the other hand, if you increase the value of
[Air Ast On(DC)], the edges of the output paper will be aligned, but a paper jam or non-feed
may occur.
4
Press the [Start] key.
Item Description Range Default
Air Ast P(S) You can select whether the
air assist function for single-
sided print is to be in the
upper curl mode or the lower
curl mode.
0: Top curl mode
1: Down curl mode
-
Air Ast P(D) You can select whether the
air assist function for double-
sided print is to be in the
upper curl mode or the lower
curl mode.
0: Top curl mode
1: Down curl mode
-
Item Description Range Default
Amount of
change
Air Ast On(TC) Adjust the timing to turn on
the air assist in the upper
curl mode.
-100 to 100 0 10msec
Air Ast Off(TC) Adjust the timing to turn off
the air assist in the upper
curl mode.
-100 to 100 0 10msec
Air Ast On(DC) Adjust the timing to turn on
the air assist in the down
curl mode.
-100 to 100 0 10msec
Air Ast Off(DC) Adjust the timing to turn off
the air assist in the down
curl mode.
-100 to 100 0 10msec
To Next Page
Loading...
