LACO Technologies TITAN Test

To Next Page

To Previous Page

LACO ORIGINAL OPERATING INSTRUCTIONS TITANTEST™

Dangerous situation resulting in minor injuries

Dangerous situation resulting in damage to property or the environ-

ment

Main Page

Table of Contents5
About this Manual9
Target Groups9
Additional Documents on the USB Stick9
Other Applicable Documents9
Displaying Information9
Warnings9
Safety11
Intended Use11
Owner Requirements11
Operator Requirements12
Dangers12
Scope of Delivery, Transport, Storage14
Description16
Function16
Main Unit16
Markings on the Device18
Technical Data18
Titan Test23
Pump down Times23
Vacuum Diagrams24
Vacuum Schematic with Internal Fore Pump24
Vacuum Schematic with Dry Scroll Pump24
Installation25
Setup25
Removal of the Plug (M-Series Only)25
Installing the External Oil Mist Filter (P-Series Only)26
Itan Test26
Mounting the Accessories27
Connecting the Sniffer Line27
Remote Control27
Fore Pump Exhaust Line28
Venting or Chamber28
5.10 Connecting to the Power Supply System28
Operation29
Switching on the Device29
Operating the Device30
Menu Tree30
Display and Buttons31
Recurring Function Symbols32
Structure of the Windows and the Menus32
Measurement Display33
Setup Window Display35
Standby36
Global Settings38
Setting the Display38
Access Control40
Set Interfaces42
Load/Save Parameters45
Volume & Beep46
Define the Auto Test Settings46
Settings for the Measurements50
Set Operating Mode and Mass50
Set Filter & ZERO51
Set Vacuum Ranges52
Define Evacuation Time & Vent53
Set Gross Leak Protection54
Define Pressure Limits for Sniff Mode55
Set the Setpoint and Alarm55
Define Calibration Settings56
Set Calibration Request57
Execute Calibration57
6.4.10.1 Calibrating in "Vacuum" Operating Mode57
6.4.10.2 Calibrate in "Sniff"Operating Mode59
6.4.10.3 Check Calibration with Internal Calibration Leak59
Measuring60
Measuring in "Vacuum" Operating Mode60
Measuring in "Sniff" Operating Mode61
Executing an Auto Test62
Measured Value Display62
Calling up Information about the Device63
Switching off the Device64
Warning and Error Messages65
Warning Messages65
Error Messages68
Maintenance, Cleaning and Service71
Important Instructions71
Cleaning the Housing71
Information Sources72
List of Documents72
Calling up Maintenance Information72
Maintenance and Service Schedule74
Maintenance Work (M-Series Only)75
The System at a Glance (M-Series Only)76
Removing the Cover (M-Series Only)77
Backing Pump (M-Series Only)77
Check Oil Level from Outside77
Replenish the Oil (M-Series Only)77
Change the Oil (M-Series Only)78
Oil Mist Filter (M-Series Only)79
Check and Empty the Oil Mist Filter and Clean the Oil Pan (M-Series Only)79
Replace the Filter of the Oil Mist Filter (M-Series Only)80
Maintenance Work (P-Series Only)81
The System at a Glance (P-Series Only)82
Removing the Cover (P-Series Only)83
Backing Pump (P-Series Only)84

LACO Technologies TITAN Test - Page 10

Table of Contents

Related product manuals