LACO ORIGINAL OPERATING INSTRUCTIONS TITANTEST™
63
© 2018 LACO TECHNOLOGIES, INC. - [TitanTest itna01en1-07 BA.fm] - 1807
8. Maintenance, Cleaning
and Service
8.1 Important instructions
When handling the gases used, comply with the applicable regulations
and safety measures.
The inert gas, helium, has an asphyxiating effect in large concentrations.
The test objects and the gas fittings must be capable of withstanding the
existing pressure differential.
For repair, sent-in products must be free of pollutants, (e.g. radioactive,
toxic, or caustic or biological substances). Otherwise the type of contam
-
ination must be declared.
The mains filter, the power supply unit, the wiring board and the backing
pump contain parts that are supplied with a voltage of 50
V. During ser-
vicing, therefore, it is necessary to always pull the mains plug before
opening the device.
Prevent the contamination of the vacuum area.
Electrical components (circuit boards, integrated circuits, electrical con-
nections) are sensitive to electrostatic charges. Use anti-static packaging
for circuit boards and Flash-ROM.
If defects arise by disregarding protective measures, warranty claims may
no longer be applicable.
LACO Technologies does not accept responsibility and warranty claims
– if the device is converted,
– if the device is operated with accessories that are not listed in the asso-
ciated product documentation.
8.2 Cleaning the housing
Risk of injury from improper maintenance work
► Maintenance work on the TITANTEST™ may only be performed by person-
nel who have been authorized by LACO Technologies to execute these
tasks.
Life threatening hazard from electric shock
Considerable voltages arise inside the device. Touching parts where electri-
cal voltage is applied can result in death.
► Disconnect the device from the power supply before any cleaning or
maintenance. Make sure that the electric power supply is reconnected
with authorization.
To Next Page
Loading...