LACO ORIGINAL OPERATING INSTRUCTIONS TITANTEST™
34
© 2018 LACO TECHNOLOGIES, INC. - [TitanTest itna01en1-07 BA.fm] - 1807
Only the menu " Setup > Information" will remain accessible without re-
strictions (see Chapter 6.6: "Calling up information about the device", page 55).
Authorization for the menu is activated if the current menu PIN is not 0000.
After activating the user authorization for the menu, the function is activat-
ed after 2 minutes. The setting can be changed in this time. Afterwards, the
correct menu PIN must be entered for access to all menus.
If you activate authorization for the menu, it is essential to memorize the
menu PIN.
If you forget the menu PIN, contact LACO Technologies.
► Select " Setup > Global settings > Access control > Change menu PIN".
6.3.3 Set interfaces
The interfaces are located on the back of the device (see Chapter Fig. 3: ,
page 9).
The menu "Interfaces" allows access to the settings for the following inter-
faces:
Analog output
Control location
Relay
Serial port
Ext. Pump Setup
► Select " Setup > Global settings > Interfaces".
Table 12: Change menu PIN
Option Value range
(Min. Max.)
Comment
New PIN 0000 - 9999 New menu PIN
New PIN
(Confirmation)
0000 - 9999 New menu PIN. Repeat to confirm.
To Next Page
Loading...
