LACO Technologies TITAN Test - 6.3 Global settings; 6.3.1 Setting the display

LACO ORIGINAL OPERATING INSTRUCTIONS TITANTEST™
30
© 2018 LACO TECHNOLOGIES, INC. - [TitanTest itna01en1-07 BA.fm] - 1807
6.3 Global settings
In order to get an overview of the setting options, please refer to the menu
tree representation (see Chapter 6.2.1: "Menu tree", page 22).
You can make your own settings or retain the factory settings (see Tab. 3:
"Factory settings", page 12).
You can save your settings at any time in order to restore an earlier condition
when necessary (see Chapter 6.3.4: "Load/Save parameters", page 37).
You can access the menus via " Setup > Global settings":
 Display
 Access control
 Maintenance & service (see Chapter 8.: "Maintenance, Cleaning and Ser-
vice", page 63)
 Interfaces
 Load/save parameters
 Volume & Beep
6.3.1 Setting the display
In the "Display" menu, you can modify the type of display by selecting the
following buttons:
 Contrast
 Units
 Date & Time
 Display range
 Lower display limit
 Language
► Select " Setup > Global settings > Display settings" and the desired
button.
Contrast Increase or decrease the contrast of the display by pressing the "+" and "-"
buttons. If you press and hold down the buttons, the values change contin-
uously.
The settings take immediate effect in the display.
► In order to adjust the contrast automatically to the device temperature,
select "Automatic".
► In order to have the background of the display dark and the letters bright,
select "Invert Display".