LACO Technologies TITAN Test - 6.2.1 Menu tree

LACO ORIGINAL OPERATING INSTRUCTIONS TITANTEST™
22
© 2018 LACO TECHNOLOGIES, INC. - [TitanTest itna01en1-07 BA.fm] - 1807
6.2 Operating the device
6.2.1 Menu tree
Welcome
Start-up (6.1) Language (6.1)
Setup (6.1)
Information (6.1)
Standby (6.2.7)Mode Select (6.2.7)
Setup (6.2.7) Global settings (6.3)Display settings (6.3.1)Contrast (6.3.1)
Units (6.3.1)
Date & Time (6.3.1)
Display range (6.3.1)
Lower display limit (6.3.1)
Language (6.3.1)
Access control (6.3.2) Maintenance enabled (6.3.2)
Access to CAL function (6.3.2)
Change device PIN (6.3.2)
Change menu PIN (6.3.2)
Maintenance & Service (8.; 8.3.2) Maintenance device (8.3.2)
Maintenance warning (8.3.2)
Burn-in (8.3.2)
Maintenance components (8.3.2)
View Maintenance interval list (8.3.2)
Service (8.3.2)
Interfaces (6.3.3) Analog output (6.3.3)
Control location (6.3.3)
Relay (6.3.3)
Serial port (6.3.3)
Ext. Pump Setup (6.3.3)
Parameter load / save (6.3.4) Load "PARA SET 1" (6.3.4)
Load "PARA SET 2" (6.3.4
Save as "PARA SET 1" (6.3.4
Save as "PARA SET 2" (6.3.4
Load factory settings (6.3.4
Volume & Beep (6.3.5)
Auto Test** (6.3.6) Auto test timer (6.3.6)
Auto test parameter (6.3.6)
Setpoint & Alarm (6.4.7)
Information (6.6)Settings (6.6)
System data (6.6)
Vacuum diagram (6.6)
Error list (6.6)
Calibration history (6.6)
Paging function (6.6)
Calibration settings (6.4.8)Calibration request (6.4.9)
Calibration leak & CAL Mode (6.4.8)
Test settings (6.4) Mode & Mass (6.4.1)
Filter & ZERO (6.4.2)
Vacuum ranges (6.4.3)
Evacuation time & Vent (6.4.4)
Gross leak protection (6.4.5)
Pressure limits for sniff mode (6.4.6)
Calibration (6.4.10)
Utilities (6.2.7) Background cleanup (6.4.4)
Check internal calibr. leak( (6.4.10.3)
Pumping down (6.2.7)
M.-mode (Bar-Graph) (6.2.5)
M.-mode (Q(t)-Graph) (6.2.5)
Warning/Error (7.) ** Feature not available in T
ITANTEST™ Maintenance model