LACO ORIGINAL OPERATING INSTRUCTIONS TITANTEST™
18
© 2018 LACO TECHNOLOGIES, INC. - [TitanTest itna01en1-07 BA.fm] - 1807
5.3 Installing the external oil mist filter (P-Series only)
► Attach the mist filter housing to the KF flange (that extends above the
cover (1).
► Connect the 6 mm drain tube to the mist filter drain fitting (2).
Note: If you want to equip an older device with the oil mist filter conversion
kit, you will receive a separate instruction sheet with the kit.
5.4 Accessories for TITANTEST™
A variety of accessories exist for the TITANTEST™ (see Chapter 9.2: "Accessories
and consumables", page 100). Refer to the Accessory Manual for information
on Installation, Operations and Maintenance of these accessories.
To Next Page
Loading...