LACO ORIGINAL OPERATING INSTRUCTIONS TITANTEST™
vi
© 2018 LACO TECHNOLOGIES, INC. - [TitanTest itna01en1-07 IVZ.fm] - 1807
6.3.2 Access control.................................................................................................32
6.3.3 Set interfaces ..................................................................................................34
6.3.4 Load/Save parameters.................................................................................37
6.3.5 Volume & Beep...............................................................................................38
6.3.6 Define the Auto Test settings**................................................................38
6.4 Settings for the measurements................................................................42
6.4.1 Set operating mode and mass .................................................................42
6.4.2 Set filter & ZERO.............................................................................................43
6.4.3 Set vacuum ranges .......................................................................................44
6.4.4 Define evacuation time & vent.................................................................45
6.4.5 Set gross leak protection............................................................................46
6.4.6 Define pressure limits for sniff mode.....................................................47
6.4.7 Set the setpoint and alarm ........................................................................47
6.4.8 Define calibration settings.........................................................................48
6.4.9 Set calibration request ................................................................................49
6.4.10 Execute calibration .......................................................................................49
6.4.10.1 Calibrating in "Vacuum" operating mode ............................................49
6.4.10.2 Calibrate in "Sniff"operating mode.........................................................51
6.4.10.3 Check calibration with internal calibration leak.................................51
6.5 Measuring ........................................................................................................52
6.5.1 Measuring in "Vacuum" operating mode.............................................52
6.5.2 Measuring in "Sniff" operating mode....................................................53
6.5.3 Executing an Auto Test**............................................................................54
6.5.4 Measured value display ..............................................................................54
6.6 Calling up information about the device .............................................55
6.7 Switching off the device .............................................................................56
7. Warning and error messages................................. 57
7.1 Warning messages........................................................................................57
7.2 Error messages ...............................................................................................60
8. Maintenance, Cleaning and Service.....................63
8.1 Important instructions ................................................................................63
8.2 Cleaning the housing ..................................................................................63
8.3 Information sources .....................................................................................64
8.3.1 List of documents..........................................................................................64
8.3.2 Calling up maintenance information.....................................................64
8.3.3 Maintenance and service schedule ........................................................66
8.4 Maintenance work (M-Series only) .........................................................67
8.4.1 The system at a glance (M-Series only) .................................................68
8.4.2 Removing the cover (M-Series only) ......................................................69
8.4.3 Backing pump (M-Series only)..................................................................69
8.4.3.1 Check oil level from outside ......................................................................69
8.4.3.2 Replenish the oil (M-Series only) .............................................................69
8.4.3.3 Change the oil (M-Series only) .................................................................70
8.4.4 Oil mist filter (M-Series only) .....................................................................71
8.4.4.1 Check and empty the oil mist filter and clean the oil pan (M-Series
only) ...................................................................................................................71
8.4.4.2 Replace the filter of the oil mist filter (M-Series only) ......................72
8.5 Maintenance work (P-Series only)...........................................................73
8.5.1 The system at a glance (P-Series only)...................................................74
8.5.2 Removing the cover (P-Series only)........................................................75
8.5.3 Backing pump (P-Series only)...................................................................76
To Next Page
Loading...
