Lantronix PremierWave XN - Wi-Fi Protected Setup (WPS); To Start WPS; To Cancel WPS; To Show WPS Status

3: Installation of the PremierWave XN Device
PremierWave® XN Intelligent Gateway User Guide 27
Wi-Fi Protected Setup (WPS)
Using WPS, you have the option of connecting to PremierWave XN devices with a router or
access point in a single operation instead of manually creating a profile with a network name
(SSID), setting up wireless security parameters and updating the choice list.
Figure 3-15 PremierWave XN WPS Button
To Start WPS
Using the Device
1. Place the end of a paper clip or similar object into the WPS opening (see Figure 3-15) and
press and hold down for a minimum of 5 seconds.
2. Remove the paper clip to release the button. The unit will start Wi-Fi protected setup.
Using the CLI
 To enter the command level: enable -> config -> if 2 -> link
To Cancel WPS
Using the CLI
 To enter the command level: enable -> config -> if 2 -> link
To Show WPS Status
Using the CLI
 To enter the command level: enable -> config -> if 2 -> link
WPS Button
(pin hole opening)
Antenna 2
Antenna 1