Lantronix PremierWave XN - Gateway and WAN Configuration

6: Network Settings
PremierWave® XN Intelligent Gateway User Guide 61
Gateway
The PremierWave XN intelligent gateway can be configured as a wireless router with DHCP
server functionality.
Status
This page displays the current configuration and statistics information for the gateway.
 To view gateway status: click Gateway on the menu and select Status.
WAN
Table 6-20 WAN Configuration
Gateway Settings Description
Operating Mode Select the type of operating mode:
 Disabled: prevents the device to be used as a gateway; use the device
normally.
 Gateway: allows the device to be used as a router with NAT.
 Router: allows the device to be used as a router without NAT.
Firewall Select to enable or disable firewall:
 Enabled: enables the device firewall.
 Disabled: disable the device firewall.
MAC Address filter Select to enable or disable the MAC address filter.
Interface Specify the WAN interface. Generally wlan0 interface.
IP Address Assign a static IP address to the gateway.
IPv6 Address Assign a static IPv6 address to the gateway.
Primary DNS Enter the IP address of the primary Domain Name Server.
Note: This setting will be used when either Static IP or Auto IP is active, or
if DHCP/BOOTP is active and no DNS server was acquired from the
server.
Secondary DNS Enter the IP address of the secondary Domain Name Server.
Note: This setting will be used when either Static IP or Auto IP is active, or
if DHCP/BOOTP is active and no DNS server was acquired from the
server.