To Next Page

To Previous Page

6: Network Settings

PremierWave® XN Intelligent Gateway User Guide 65

To Configure Gateway DHCP Server Settings

Using Web Manager

 To modify gateway DHCP server information, click Gateway on the menu and select

Configuration > DHCP Server.

Using the CLI

 To enter the gateway command level: enable -> config -> gateway -> dhcp

server

Using XML

 Include in your file:

Routing Protocols

The PremierWave XN intelligent gateway allows the configuration of routing protocols. Routing

protocols specify how routers communicate with each other, disseminating information that

enables the selection of routes between any two nodes on a computer network. Routing

algorithms determine the specific choice of route. Each router has a prior knowledge of networks

directly attached to it. A routing protocol shares this information among immediate neighbors first,

then through the network. This way, routers gain knowledge of the topology of the network. The

PremierWave device supports RIP and OSPF protocols.

Table 6-27 Routing Protocol Settings

Routing Settings Description

State (RIP) Select to enable or disable the RIP state.

Version Select how the RIP is to be configured. It can accept Version 1, Version 2,

or Version 1 and 2.

Update Interval Indicate the number of seconds for the Update Interval. Send unsolicited

Response message every Update Interval seconds containing the complete

routing table to all neighboring RIP routers.

Timeout Interval Indicate the number of seconds for the Timeout Interval. Upon expiration of

the Timeout Interval, the routes are no longer valid, however, they are

retained in the routing table for a short time so that neighbors can be notified

that the route has been dropped.

GC Interval Indicate the number of seconds for the GC Interval. Upon expiration of the

GC Interval, the routes are finally removed from the routing table.

State (OSPF) Select to enable or disable the OSPF state.

Hello Interval Indicate the number of seconds for the Hello Interval. Hello packet will be

sent every Hello Interval seconds.

Dead Interval Indicate the number of seconds for the Dead Interval. Sets the time period

for which hello packets must not have been seen before neighbors declare

the router down.

Lantronix PremierWave XN User Manual

Other manuals for Lantronix PremierWave XN