Lantronix PremierWave XN - Protocol Stack Settings: IP and ICMP

10: Maintenance and Diagnostics Settings
PremierWave® XN Intelligent Gateway User Guide 95
To Transfer or Modify Filesystem Files
Using Web Manager
 To create a new file or directory, upload an existing file, copy or move a file, click Filesystem
in the menu and select Browse.
Using the CLI
 To enter the Filesystem command level: enable -> filesystem
Using XML
 Not applicable.
Protocol Stack Settings
There are various low level network stack specific items that are available for configuration. This
includes settings related to IP, ICMP, ARP and SMTP, which are described in the sections below.
IP Settings
Table 10-5 IP Protocol Stack Settings
TFTP
Action Select the action that is to be performed via TFTP:
 Get = a “get” command will be executed to store a file locally.
 Put = a “put” command will be executed to send a file to a remote
location.
Local File Enter the name of the local file on which the specified “get” or “put” action is
to be performed.
Remote File Enter the name of the file at the remote location that is to be stored locally
(“get’) or externally (“put”).
Host Enter the IP address or name of the host involved in this operation.
Port Enter the number of the port involved in TFTP operations.
Protocol Stack
IP Settings
Description
IP Time to Live This value typically fills the Time To Live in the IP header. SNMP refers to this
value as "ipDefaultTTL".
Enter the number of hops to be transmitted before the packet is discarded.
Multicast Time to Live This value fills the Time To Live in any multicast IP header. Normally this value
will be one so the packet will be blocked at the first router. It is the number of
hops allowed before a Multicast packet is discarded.
Enter the value to be greater than one to intentionally propagate multicast
packets to additional routers.
File Transfer Settings Description