Lantronix PremierWave XN - To Configure IP Protocol Stack Settings; ICMP Settings; To Configure ICMP Protocol Stack Settings; ARP Settings

10: Maintenance and Diagnostics Settings
PremierWave® XN Intelligent Gateway User Guide 96
To Configure IP Protocol Stack Settings
Using Web Manager
 To configure IP protocol settings, click Protocol Stack in the menu and select IP.
Using the CLI
 To enter the command level: enable -> config -> ip
Using XML
 Include in your file: <configgroup name=”ip”>
ICMP Settings
Table 10-6 ICMP Protocol Stack Settings
To Configure ICMP Protocol Stack Settings
Using Web Manager
 To configure ICMP protocol settings, click Protocol Stack in the menu and select ICMP.
Using the CLI
 To enter the command level: enable -> config -> icmp
Using XML
 Include in your file: <configgroup name=”icmp”>
ARP Settings
Table 10-7 ARP Protocol Stack Settings
Protocol Stack
ICMP Settings
Description
State The State selection is used to turn on/off processing of ICMP messages.
This includes both incoming and outgoing messages. Choose Enabled or
Disabled.
Protocol Stack
ARP Settings
Description
IP Address Enter the IP address to add to the ARP cache. After entering the MAC address, click
the Add button.
MAC Address Enter the MAC address to add to the ARP cache. After also entering the IP address,
click the Add button.
Remove Click the Remove link beside a specific address to remove it.