Lantronix PremierWave XN User Manual

6: Network Settings
PremierWave® XN Intelligent Gateway User Guide 50
To View WLAN Link Scan and Status Information
Using Web Manager
 To scan the wireless (wlan0) Link, click Network in the menu and select Network 2 -> Link ->
Scan.
 To view the wireless (wlan0) Link status information, click Network in the menu and select
Network 2 -> Link -> Status.
Using the CLI
 To enter the wlan0 Link command level: enable -> config -> if 2 -> link
Using XML
 Include in your file:
<statusgroup name="interface" instance="wlan0">
and
<statusgroup name="wlan scan"></statusgroup>
Network 2 (wlan0) Failover
The PremierWave XN intelligent gateway provides wlan0 failover, in the form of a "dead remote
host reachability" mechanism (essentially a ping against a known host). If the remote host is
determined to be not reachable, the device will failover to the Ethernet interface. If the remote host
is determined to be reachable, the device will failback to the Wi-Fi interface.
Table 6-12 Network 2 (wlan0) Failover Settings
Network 1 (Failover)
Settings
Description
State Click to enable or disable state.
Failover Interface
Always select eth0 in the PremierWave
XN intelligent gateway.
Hostname Enter the remote host to test reachability.
Method Select ICMP or TCP based ping.
Timeout Indicate the interval to wait for ping response from remote host.
Interval Indicate the interval in which to test reachability
Failover Threshold Indicate the allowed number of failed pings – after which the device will
failover to the wlan0 interface.
Failback Threshold Indicate the number of successful pings – after which the device will failback
to the Ethernet interface.

Lantronix PremierWave XN Specifications

General

Brand	Lantronix
Model	PremierWave XN
Category	Server
Language	English