8: Line and Tunnel Settings
PremierWave® XN Intelligent Gateway User Guide 79
To Configure Line Command Mode
Using Web Manager
To configure a specific line in Command Mode, click Line in the menu and select Line 1 ->
Command Mode (Table 8-2).
Using the CLI
To enter Line 1 command level: enable -> line 1
Using XML
Include in your file: <configgroup name="line" instance="1">
Include in your file: <configgroup name="serial command mode" instance="1">
Tunnel Statistics
Tunnel statistics contains data counters, error counters, connection time and connection
information. Statistics are available at each individual connection and aggregated across all
connections.
Note: The following section describes the steps to view Tunnel 1 statistics; these steps
apply to other tunnel instances of the device.
To View Tunnel Statistics
Using Web Manager
To view statistics for a specific tunnel, click Tunnel in the menu and select the Tunnel 1 ->
Statistics.
Using the CLI
To view Tunnel 1 statistics: enable -> tunnel 1, show statistics
Using XML
Include in your file: <statusgroup name=”tunnel” instance=”1”>
To Next Page
Loading...
