EasyManuals Logo

Lantronix PremierWave XN User Manual

Lantronix PremierWave XN
143 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
PremierWave® XN Intelligent Gateway User Guide 38
6: Network Settings
The Network Settings show the status of the Ethernet and WLAN device interface/link and lets you
configure the settings on the device. Interface settings are related to the configuration of the IP
and related protocols. Link settings are related to the physical link connection, which carries the IP
traffic.
The PremierWave XN device server contains two network interfaces. Both interfaces will be
activated and controlled by the bridging subsystem when bridging is enabled.The Ethernet
interface is called Network 1 or eth0, and the WLAN interface is called Network 2 or wlan0
Notes:.
Some settings require a reboot to take effect. These settings are noted below.
Wait a minimum of 25-30 seconds after rebooting the unit before attempting to make
any subsequent connections.
The blue text in the XML command strings of this chapter are to be replaced with a
user-specified name.
Network 1 Status
In the Network 1 status pages, you can view both the current interface operational settings as well
as the settings that would take effect upon a device reboot, as well as Link, QoS and Failover
status information.
To view Ethernet (eth0) Interface status, click Network on the menu and select Network 1 ->
Interface -> Status.
To view Ethernet (eth0) Link status, click Network on the menu and select Network 1 -> Link
-> Status.
To view Ethernet (eth0) QoS status, click Network on the menu and select Network 1 -> QoS
-> Status.
To view Ethernet (eth0) Failover status, click Network on the menu and select Network 1 ->
Failover -> Status.
Network 1 (eth0) Interface Settings
Table 6-1 shows the network interface settings that can be configured.
These settings apply to both the Network 1 Ethernet (eth0) and the Network 2 WLAN (wlan0)
interfaces, but are configured independently for each interface.
Table 6-1 Network Interface Settings
Network Interface
Settings
Description
State Select to enable or disable the interface.
IPv4 State Select to enable of disable the IPv4 state.

Table of Contents

Other manuals for Lantronix PremierWave XN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix PremierWave XN and is the answer not in the manual?

Lantronix PremierWave XN Specifications

General IconGeneral
BrandLantronix
ModelPremierWave XN
CategoryServer
LanguageEnglish

Related product manuals