6: Network Settings
PremierWave® XN Intelligent Gateway User Guide 51
To Configure Network 2 Failover Settings
Using Web Manager
To modify Failover settings, click Network on the menu and select Network 2 > Failover >
Configuration.
Using the CLI
To enter the wlan0 link command level: enable -> config -> if 2 -> failover
Using XML
Include in your file: <configgroup name="network failover" instance="wlan0">
WLAN Profiles
A WLAN profile defines all of the settings necessary to establish a wireless connection with either
an access point (in infrastructure mode) or another wireless client (in Adhoc mode, limited to four
connections.) A maximum of eight profiles can exist on the PremierWave XN intelligent gateway
at a time. All enabled profiles are active.
The PremierWave unit now supports dynamic profiles and prioritization of the profiles. Dynamic
Profiles are the ones created via WPS or QuickConnect. Profiles are numbered based on priority.
Dynamic profiles (in reversed order of creation), choice list profiles (Choice1, Choice2, Choice3,
and Choice4), and then the remaining profiles. Use the number from output of 'show' command.
To Configure WLAN Profiles
You can view, edit, create or delete a WLAN profile.
Using WebManager
Click WLAN Profiles on the menu.
Using the CLI
To enter the wlan0 Profile command level: enable -> config -> wlan profiles
Using XML
Include in your file: <configgroup name="wlan profile"
instance="profile_name">
To Next Page
Loading...
Need help?
General