LAUNCH PAD V
User's Manual
79
7 Horizontal Settings Panel: Controls the time base.
8
Vertical Settings Panel: Controls the amplitude of the
displayed signal. User can change the volt/div, coupling and
probe attenuation of the CH1/CH2/CH3/CH4.
9 Trigger Settings Panel: Controls the start event of the sweep.
10 Channel Selection Button
11
Function Menu
[Auto]: It indicates auto trigger setting.
[Ref]: There are expert reference and base reference
available. Expert reference enables you to recall your
customized expert database, whereas base reference
provides automatic pre-setting function of specialized sensors.
[File]: Provides save snapshot, snapshot manager,
waveform record and waveform replay.
[View]: Calibration and display settings are available.
[Measure]: Includes signal source measurement, horizontal
measurement, vertical measurement and clear measurement.
[Settings]: Shows/hides the parameter settings area
including horizontal settings, vertical settings and trigger
settings.
/ [Start/Stop]: Starts/stops collecting waveforms.
7.3.4 Operations
7.3.4.1 Channel selection and attributes setting
<1> Channel selection
There are two ways available for channel selection:
A. Select from the channel tab shown at the bottom of the waveform
display area
B. Select from Vertical settings
*Note: For better comparison and identification, each channel and
waveform are marked in different colors.
<2> Channel attributes & trigger setting
Channel attributes can be set via horizontal settings and vertical
settings.
Horizontal Settings
User can make some settings directly by tapping < or > next to
options.
Time/DIV: Horizontal scale. If the waveform acquisition is stopped
To Next Page
Loading...
