PPC600 Family Debugger | 4
©
1989-2022 Lauterbach
SYStem.Option.PPCLittleEnd PPC little endian mode 47
SYStem.Option.PTE Evaluate PTE table for address translation 48
SYStem.Option.RESetBehavior Set behavior when target reset detected 48
SYStem.Option.ResetMode Select reset mode for SYStem.Up 49
SYStem.Option.SLOWRESET Relaxed reset timing 49
SYStem.Option.STEPSOFT Use alternative method for ASM single step 50
SYStem.Option.WaitReset Set reset wait time 51
SYStem.Option.WATCHDOG Leave software watchdog enabled 52
CPU specific MMU Commands ........................................................................................ 53
MMU.DUMP Page wise display of MMU translation table 53
MMU.List Compact display of MMU translation table 55
MMU.SCAN Load MMU table from CPU 57
MMU.Set Write MMU TLB entries to CPU 58
CPU specific BenchMarkCounter Commands ................................................................ 59
BMC.<counter>.FREEZE Freeze counter in certain core states 59
BMC.FREEZE Freeze counters while core halted 60
CPU specific TrOnchip Commands .................................................................................61
TrOnchip.DISable Disable debug register control 61
TrOnchip.ENable Enable debug register control 61
TrOnchip.CONVert Adjust range breakpoint in on-chip resource 61
TrOnchip.VarCONVert Adjust complex breakpoint in on-chip resource 62
TrOnchip.RESet Reset on-chip trigger settings 62
TrOnchip.state Display on-chip trigger window 62
TrOnchip.TEnable Set filter for the trace 62
TrOnchip.TOFF Switch the sampling to the trace to OFF 63
TrOnchip.TON Switch the sampling to the trace to “ON” 63
TrOnchip.TTrigger Set a trigger for the trace 63
Mechanical Description .................................................................................................... 64
JTAG/COP Connector PPC603e/700/MPC8200 64
Technical Data ................................................................................................................... 65
To Next Page
Loading...
